Sales order screen
Figure 71: Sales order screen
This screen allows definition of the sales order parameters. The commissioning date is entered by
the Service Technician at the time of chiller commissioning. These values should never be changed
or entered by anyone other than a qualified Service Technician. Entry instructions are included in
the OptiView Control Center – Service Instructions (Form 160.76-M1). The remainder of the values are
entered at the YORK Factory during the manufacturing of the chiller.
When changing a Microboard it may be necessary to enter all of these parameters in the field. The
Service Technician can request an Admin Password to allow editing of all fields. The program uses
the Sales Order information to automatically configure some of the setpoints so, it is very important
to fill in all of the information.
Table 140: Display only fields
Field/LED name Description
Model Number Factory defined model number of the chiller system.
Panel Serial Number Factory defined serial number for the micropanel.
Chiller Serial Number Factory defined serial number for the chiller system.
YORK Order Number Factory defined order number under which the chiller was sold.
System Information Factory defined conditions for which the chiller was originally rated and sold.
Condenser and Evaporator Design
Load Information
Factory defined description of the condenser and evaporator configuration at time of
shipment.
Nameplate Information Factory defined information about the chiller motor configuration.
Note: For fields requiring access level of SERVICE. Service Technicians refer to the OptiView
Control Center - Service Instructions (Form 160.76-M1) for operation instructions and explanation
of all programmable setpoints and displayed values.
139Model YK Style H Centrifugal Liquid Chillers with OptiView Control Center
To Next Page
Loading...
