You-Q ALEX - Component Removal for Transport

5.2.6. Replace an anti-tip wheel
Preparation
1. Prepare the wheelchair for maintenance. See section 5.1.
2. Lift the wheelchair until the wheels are free from the floor.
• Use a lifting platform.
3. Remove the drive wheel for easy access. See section 5.2.4.
Procedure for standard FWD
1. If the complete assembly (B) needs
replacement:
• Remove the screws A and the support
bracket C.
2. If only the wheel (E) needs replacement:
• Remove the screw, washer and nut D.
3. Install the new parts.
C
A
B
E
D
Procedure for standard RWD
1. If the complete assembly (B) needs
replacement:
• Remove the screws A.
2. If only the wheel (D) needs replacement:
• Remove the screw, washer and nut C.
3. Install the new parts.
A
B
D
C
Procedure for ShortBase RWD
1. If the complete assembly (B) needs
replacement:
• Remove the motor screw (D).
• Remove the suspension screw (C).
• Remove the mounting screw (A).
2. If only the wheel (F) needs replacement:
• Remove the screw, washer and nut E.
3. Install the new parts.
A
B
C D
F
E
Maintenance tasks & adjustments
22
Service manual - Alex