5.3. Interface (all types)
5.3.1. Adjust the position of the interface
The position of the interface can be adjusted in order to give the wheelchair better driving
characteristics. This position depends on the seat depth (as set on the seating system) and
the drive type (front wheel drive or rear wheel drive).
Preparation
1. Set the interface in the maximum tilted position for easy access.
2. Prepare the wheelchair for maintenance. See section 5.1.
3. Disconnect the interface cables from the controller.
Procedure
1. Remove the screws A (4x).
2. Move the interface (B) to the desired new
position.
3. Fasten the screws A (4x).
4. Check if the wheelchair is stable in all
available positions for seat lift and tilt.
5.3.2. Adjust the base height of the interface
The height of the interface can be adjusted in order to achieve the seat height as required
for the user.
Preparation
1. Remove the interface, including the seating system from the wheelchair, for easy
access.
2. Prepare the wheelchair for maintenance. See section 5.1.
Procedure
1. Unlock the interface mounting frames by
squeezing the locking lip (A) and turning the
locking pin (B) forward.
2. Remove the locking pin.
3. Repeat these steps for the locking pin at the
other side of the wheelchair.
To Next Page
Loading...
