How to fix a blank display on YSI Measuring Instruments?
If your YSI Measuring Instruments display is blank, first, replace the batteries or test the power supply. If you're using a 5011 adapter, unplug it from the power supply connector. If the issue persists, it could be an internal power supply failure, in which case you should verify circuit operation using a DVM and consider replacing the PCB.
What to do if YSI Measuring Instruments show error E2: Check Membrane?
If your YSI Measuring Instruments show 'E2: Check Membrane', it could be due to high background current (DO), so refer to the calibration procedure. Also, check the probe zeroing procedure. The probe may need servicing, so follow the probe maintenance instructions, or the probe might be malfunctioning, requiring repair or replacement.
What does error E1 mean on YSI Measuring Instruments and how to fix it?
If your YSI Measuring Instruments display 'E1: Check Probe', begin by checking the probe connection. If the connection is not the issue, there may be an intermittent connection in the cable or plug, which would need repair or replacement. Also, the probe thermistor may be defective; it should measure 2252 ? @ 25oC, so replace the probe sensor assembly if needed. Another reason can be that the temperature is over range, so repair or replace the defective parts.
Why does my YSI Measuring Instruments show error E5: Check Membrane?
If your YSI Measuring Instruments display 'E5: Check Membrane', it could be because the DO is unstable, so replace the membrane and KCl. The probe electrodes might need servicing, so refer to the probe maintenance instructions. Also, check the probe connection to ensure the connector is properly installed. Intermittent connections in the cable or plug can cause this, so replace the defective assembly. In some cases, the probe itself might be malfunctioning, requiring replacement.
What causes error E3 on YSI Measuring Instruments?
If your YSI Measuring Instruments show 'E3: Check Membrane', it could be due to low DO current, so install a new membrane and KCl. Also, the electrodes may be contaminated, so follow the probe maintenance instructions. If the membrane is too thick, try another membrane. High resistance in the probe connection can also cause this error, so repair or replace the connection.
What to do if YSI Measuring Instruments show error E4: Check Membrane?
If your YSI Measuring Instruments display 'E4: Check Membrane', it might be due to high DO current, so install a new membrane and KCl. The electrodes may need resurfacing, so follow the probe maintenance instructions. A short circuit in the probe, cable, or connector could also be the cause, so replace the defective assembly.
General| Parameters Measured | Dissolved Oxygen, Temperature |
|---|---|
| Dissolved Oxygen Range | 0 to 50 mg/L |
| Display | LCD |
| Manufacturer | YSI |
| Model | 5000 |
| Accuracy | ±0.2 mg/L for DO |
| Resolution | 0.01 mg/L for DO |
| Power Supply | Battery powered |
| Application | Laboratory and field water quality measurements |
To Next Page
