YSI 5000 - Appendix D - Remote Command Language

65
19. Appendix D - Remote Command Language
Remote commands and data output are available only when the instrument is in the Remote
mode.
Command Format:
<Prefix><Command Type><Parameter><Suffix>
Prefix:
The prefix consists of the two character sequence <ESC>&. In HEX this is 1B 26.
Suffix:
The suffix consists of the two character sequence <CR><LF>. In HEX this is 0D 0A.
Command Types and Parameters:
Command types are arranged into two groups, immediate and automatic.
The Display command controls the display of remote messages.
Command type parameter description
D 0 string echoes the string to the first line of the display
D 1 string echoes the string to the second line of the display
D 2 none Clear display lines 0 and 1
D 3 0 Set display update flag line 0
D 3 1 Set display update flag line 1
The ouTput mode command controls how data flow is controlled. A bar code scan in T1 or T2
mode will cause a line of output, just as if the T command had been received.
Command type parameter description
T 0 none Continuous data output
T 1 none One line of data output in response
T 2 none One line after stable reading