Yueming CMA0604-B-A - Chapter 2 Safety Rules; 2.1 Product safety; 2.2 Safe equipment; 2.3 Safety awareness

11
Chapter2 Safety Rules
This chapter mainly introduces safety warnings for protecting personnel and the equipment. The equipment
is already equipped with sufficient safety guarantee, yet it is still with certain risk. All the operators are required
to carefully read through and well understand the safety rules.
2.1 Product safety
The following conditions are required to be satisfied to ensure safe work:
 Abide by operation manual and instruction signs;
 Operators and maintenance personnel have received training held by equipment manufacture;
 In case of operation by couples of person at the same time, division of responsibility should be made
and followed;
 No admission to the working area for the unauthorized personnel;
 Avoid any working method breaking the safety rules;
 Timely eliminate all the failures possibly causing lower safety coefficient;
 Abide by maintenance regulations of the equipment
2.2 Safe equipment
Safety equipments are used for protecting personnel, and unauthorized disassembly, bridge-group or
by-pass connection are strictly prohibited; in case of failure with the safety equipment, professional are required
for repair. If part replacement is needed, the product with same model, specification and from the same
manufacture is required; otherwise, written consent from the manufacturer is required.
2.3 Safety awareness
The equipment can be operated only by skilled personnel or under supervision of them. Improper use or
operation may possibly be very dangerous and cause damage to the machine. Therefore, the followings are
strictly prohibited:
 Placing heavy objects or stepping on the working table of the equipment;
 Used for processing the materials unapproved by manufacturer;
 Staying of unauthorized personnel in the dangerous area (It is the responsibility of operators to ensure
keeping unauthorized personnel away from the working area.);
 Block of using emergency stop button (Regular check is required to ensure a good condition for the
emergency stop button.);
2.4 Requirements for personnel
After trail operation, maintenance personnel from the manufacturer may perform training on the operators;
It is the responsibility of equipment owner to have operators trained at corresponding level;