Z-EDGE Z3D User Manual

-7-
2.3 Adjust Device Position
1. Loosen the nut to swivel the device vertically. Click into place and secure by
tightening the nut.
2. Swivel the device horizontally for a clear view.
2.4 Connecting to Power
Use only the supplied USB car charger to power the dash cam and charge the
built-in battery.
1. Slide the GPS Suction Mount into the slot on top of the dash cam until a
click sound is heard.
2. Plug the Micro USB Cable of GPS (13) into the dash cam's Micro USB Port (7).
3. Plug one end of the USB charging cable into the Micro USB Port of GPS (15).
4. Plug the other end into the USB car charger, and insert the charger into your
vehicle's cigarette lighter socket.
• Once the vehicle's engine is switched on, the dash cam will automatically
power on.
• When the vehicle engine is switched off, the dash cam will automatically save
the recording and power off within 5 seconds.
Automatic Power
1 2

Z-EDGE Z3D Specifications

General

Brand	Z-EDGE
Model	Z3D
Category	Dash Cameras
Language	English