What to do if Zanussi Dishwasher shows iF1 error?
If the level of water inside the Zanussi Dishwasher is too high and the display shows iF1, switch the appliance off and on, ensure that the filters are clean, and verify that the outlet hose is installed at the correct height above the floor. Refer to the installation instructions for guidance.
How to fix rattling sounds in Zanussi ZDLN7530?
To resolve rattling or knocking sounds from inside your Zanussi Dishwasher, ensure the tableware is properly arranged in the baskets and that the spray arms can rotate freely. Refer to the basket loading leaflet for guidance.
Why Zanussi ZDLN7530 trips the circuit breaker?
If your Zanussi Dishwasher is tripping the circuit breaker, it may be due to insufficient amperage to supply all appliances in use simultaneously. Check the socket amperage and the capacity of the meter, or turn off one of the appliances in use. If the issue persists, it could indicate an internal electrical fault, and you should contact an Authorised Service Centre.
Why the Zanussi ZDLN7530 Dishwasher programme does not start?
If your Zanussi Dishwasher isn't starting, ensure the appliance door is closed properly. If the delay start function is active, either cancel it or wait for the countdown to finish. Also, the appliance may be recharging the resin inside the water softener, which takes approximately 5 minutes.
How to improve drying results in Zanussi ZDLN7530?
If you experience poor drying results with your Zanussi Dishwasher, activate the AirDry function, ensure the rinse aid dispenser is filled to the correct level, use rinse aid even with multi-tablets, and consider that plastic items may need to be towel dried. Also, check if the selected program includes a drying phase. The quality of the rinse aid can also be the cause.
What to do if the anti-flood device is on in Zanussi ZDLN7530 Dishwasher?
To prevent the anti-flood device from activating on your Zanussi Dishwasher and displaying 'i30', close the water tap, ensure the appliance is correctly installed, and load the baskets as instructed in the user manual.
How to fix a leaky Zanussi ZDLN7530 Dishwasher door?
To fix a small leak from the Zanussi Dishwasher door, ensure the appliance is level by adjusting the adjustable feet and that the door is centered on the tub by adjusting the rear foot.
Why Zanussi ZDLN7530 is not filling with water?
If your Zanussi Dishwasher is not filling with water and the display shows i10 or i11, make sure the water tap is open, the water supply pressure is adequate, the water tap and the filter in the inlet hose are not clogged, and the inlet hose has no kinks or bends. Contact your local water authority to check the pressure of the water supply.
General| Type | Freestanding |
|---|---|
| Energy Efficiency Class | D |
| Number of Place Settings | 13 |
| Noise Level | 44 dB |
| Delay Start | Yes |
| Half Load Option | Yes |
| Drying System | AirDry |
| Plumbing | Cold or hot |
To Next Page
