the cross / square fully. Induction cooking
zones adapt to the dimension of the bottom
of the cookware automatically. You can cook
with the large cookware on two cooking
zones at the same time.
5.5 Automatic Heat Up
If you activate this function you can get a
necessary heat setting in a shorter time. The
function sets the highest heat setting for
some time and then decreases to the correct
heat setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch ( comes on). Immediately
touch
( comes on). Immediately touch
until the correct heat setting comes on.
After 3 seconds comes on.
To deactivate the function: touch .
5.6 PowerBoost
This function makes more power available to
the induction cooking zones. The function
can be activated for the induction cooking
zone only for a limited period of time. After
this time the induction cooking zone
automatically sets back to the highest heat
setting.
Refer to “Technical data”
chapter.
To activate the function for a cooking
zone: touch . comes on.
To deactivate the function: touch
or .
5.7 Timer
• Count Down Timer
You can use this function to set the length of
a single cooking session.
First set the heat setting for the cooking
zone, then set the function.
To set the cooking zone: touch
repeatedly until the indicator of a cooking
zone appears.
To activate the function or change the
time: touch or of the timer to set the
time (00 - 99 minutes). When the indicator of
the cooking zone starts to flash, the time
counts down.
To see the remaining time: touch
to set
the cooking zone. The indicator of the
cooking zone starts to flash. The display
shows the remaining time.
To deactivate the function: touch to set
the cooking zone and then touch . The
remaining time counts down to 00. The
indicator of the cooking zone disappears.
When the countdown ends, an
acoustic signal sounds and 00
flashes. The cooking zone
deactivates.
To stop the sound: touch .
• Minute Minder
You can use this function when the hob is
activated and the cooking zones do not
operate. The heat setting display shows
.
To activate the function: touch
and then
touch
or of the timer to set the time.
When the time finishes, an acoustic signal
sounds and 00 flashes.
To stop the sound: touch .
To deactivate the function: touch
and
then touch
. The remaining time counts
down to 00.
The function has no effect on the
operation of the cooking zones.
5.8 Lock
You can lock the control panel while cooking
zones operate. It prevents an accidental
change of the heat setting.
Set the heat setting first.
10 ENGLISH
To Next Page
Loading...
Need help?
General
Weight and Dimensions
