The Competition 2000 4 Channel Amps
To accompany the two channel C2K amps, we offer the 4 channel
versions, the C2K 2.5X and the 4.0X. In addition to all the standard C2K
features, we have made some changes to greatly increase the value of our
four channel amps.
First, with the C2K series, all ZAPCO 4 channel amps have
independent, fully variable crossovers for front and rear amps.
Second, each end of the amps can be easily switched to a single
channel mono input so they can be used as true stereo amps while
“building” a larger system.
Finally, we have effectively doubled the power of our Competition 4
channel amps. The competition series was conceived and designed for the
serious competitor. Since it was capable of operating at loads as low as 1
Ohm, you could “load down” the amp with multiple woofers and get up to
three times the amps rated power. While this is a great advantage for
woofers, it is usually a disadvantage for sound quality, as all specifications
are better at 4 ohms. Since the competition series is a dedicated Sound
Quality product, it is only appropriate that it should operate best at a 4 ohm
load.
Of course, all the C2K features like sub-sonic filter, RSD port, variable
turn-on delay, and slave output for “daisy chaining” amps are included with
the new competition 4 channels as well.
Moreover, as with every ZAPCO product, the C2K four channels are
made right here in Modesto, California, by people who care about sound
and about quality.
Never before, have there been such versatile amplifiers as the
Competition 2000, four channels, from ZAPCO.
If you should have any questions or comments about your ZAPCO
C2K four channel, please contact us at (209) 577-4268 or
www.zapco.com.
To Next Page
Loading...
Need help?
General