Zapi SEM1 - Page 23

Page 23SEM1
Programming operations through the console:
1) Opening display.
2) Press ENTER to enter the main menu .
3) The headline of the first item,
PARAMETER CHANGE appears.
4) Press ENTER to enter to the function PARAMETERS.
5) The first parameter of the list appears.
6) Scroll the list of the parameters with the
buttons ROLL UP and ROLL DOWN.
7) Another parameter appears.
8) Change the programmed level by means of the
SET UP and SET DOWN buttons.
9) The new set value appears.
10) Press OUT when programming is finished.
11) The confirmation request appears.
12) Press ENTER to confirm the modifications
or OUT to cancel.
13) The headline of the menu
PARAMETER CHANGE appears.
14) Press ROLL UP or ROLL DOWN for scrolling
the other items, or press OUT for coming back
to the opening display.