ZCS Azzurro 3000SP - Page 55

55 / 58
Identificazione: MD-AL-GI-00
Rev. 4.0 del 31.01.18 - Applicazione: GID
Manual of 11/06/2019 Rev. 1.8 “User Manual for 3000SP storage inverter”
W
ID76
unrecover
EEPROM_
R
Unreadable EEPROM
ID77
unrecover
RelayFail
Permanent fault on
relays
ID81
Over
Temperatu
re
Internal temperature
is too high.
1) Check that the 3000SP inverter is installed in a place
without direct sunlight / other heat sources.
2) Check that the 3000SP inverter is installed vertically and
that the ambient temperature is less than that allowable
by the 3000SP
ID82
Over
Frequency
AC frequency is too
high.
Refer to ID01
ID85
Battery
Voltage is
low
Battery voltage is
low
Minimum voltage level has been reached. It will not be
possible to discharge the battery any further unless it
is recharged.
ID94
Software
version is
not
consistent
The firmware
version installed is
not suitable for the
type of inverter.
Contact Technical Support
ID95
CommEEP
ROMFault
EEPROM of the
communication
board cannot be
read
ID95-ID96 are internal errors of 3000SP
Switch off the unit by disconnecting the AC and DC
switches, and wait for at least 5 minutes. Switch the
unit back on again by closing the AC and DC switches,
and check if the error is still present. If so, contact
Technical Support.
ID96
RTCFault
Clock error
ID97
InValidCou
ntry
Country selected is
not valid
Check the country code setting
ID98
SDfault
SD card error
Extract the SD card and clean it with a dry cloth.
If the error persists, replace the SD card with a new
one.
ID100
BatOCD
Overcurrent
protection of battery
discharge
ID100-ID103 are battery errors.
If the case of occasional errors, wait a few minutes to
see if the error disappears.
If the error persists, contact Technical Support.
ID101
BatSCD
Short circuit
protection of battery
discharge
ID102
BatOV
Battery overvoltage
protection
ID103
BatUV
Battery
undervoltage
protection