Warning - Shock Hazard
The printer should never be operated in a location where it can get wet.
Personal injury could result.
Warnung - Stromschlaggefahr - Der Drucker sollte nie an feuchten
Standorten in Betrieb genommen werden. Es besteht erhöhte Verletzungs
und Unfallgefahr.
Warning - Static Discharge
The discharge of electrostatic energy that accumulates on the surface of
the human body or other surfaces can damage or destroy the printhead or
electronic components used in this device. DO NOT TOUCH the
printhead or the electronic components under the printhead assembly.
Caution - Printer Setup & Handling
1)When installing or modifying the printer setup or configuration,
ALWAYS TURN POWER OFF Before
:
A) Connecting any cables.
B) Performing any cleaning or maintenance operations.
C) Moving the printer.
2) Damage to the printer interface connector, accessories or enclosure
may result from placing the printer on it’s front bezel or backside during
unpacking or handling.
Media Cautions & Tips
If poor quality, adhesive backed labels are used, with labels that DO NOT
lay flat on the backing liner, the exposed edges may stick to the label
guides and rollers inside the printer, causing the label to peel off from the
liner and jam the printer.
Media Reload Tip
If you should run out of labels while printing, DO NOT turn the power
switch OFF (0) while reloading or data loss may occur. The printer will
automatically resume printing when a new media roll is loaded.
Print Quality Tip
Print density (darkness) is affected by the heat energy (density setting)
applied and by the print speed. Changing both Print Speed and Density
may be required to achieve the desired results.
iv 980428-001 Rev. A