Data Capture
104
Scanning with the Internal Imager
The device contains the DataWedge app that allows the user to enable the imager, decode the barcode data,
and display the barcode content.
To scan a barcode using the DataWedge app:
1. Swipe up from the bottom of the screen to display the App screen.
2. Touch to open the DataWedge Demonstration app.
3. Touch to turn on the red decode illumination.
4. Present a barcode. Use the LED dot within the illumination to position the barcode in the correct field of
view. (The aiming dot increases visibility in bright lighting conditions.)
Figure 64 Correct and Incorrect Scanning
Figure 65 Pick List Mode with Multiple Barcodes
IMPORTANT: To read a barcode, a scan-enabled app is required on the device.
NOTE: When the device is in Picklist mode, the imager does not decode the barcode until the aiming dot touches
the barcode.
To Next Page
Loading...