Data Capture
109
Scanning with the DS8108 Corded Scanner
The DS8108 digital scanner is in Hands-free (presentation) mode when it is placed in the Intellistand. In this
mode, the digital scanner operates in continuous (constant-on) mode, where it automatically decodes a bar
code presented in its field of view.
When the digital scanner is not used for a user-definable period of time, it enters a low power mode in which
the LEDs are turned off or illumination blinks at a low duty cycle until the digital scanner detects an image
change (e.g. motion).
To scan with the DS8108:
1. Place the aiming dot over the bar code. See DS81X8 Aiming below.
Figure 71 DS8108 Aiming Dot on Bar Code
2. Press and hold the trigger until either:
a. The digital scanner reads the bar code. The digital scanner beeps, the LED flashes, and the scan line
turns off.
or
b. The digital scanner does not read the bar code and the scan line turns off.
3. Release the trigger.
To Next Page
Loading...