Getting Started
Hooking Up the Printer and Computer
22
980611-001 Rev. B GX420d User Guide 6/4/08
Parallel Port
The required cable must have a twenty-five pin “D” type (DB-25P) male connectors on both
ends with a straight through wiring connections (IEEE 1284 A-A parallel interface
specification). Tighten the cable connector’s screw locks to secure the cable to the printer and
computer.
Note • The printer design does not allow for the use non-molded cables such as hand-made
cables with clam shell connector covers.
To Next Page
Loading...
