Accessories
109
2.
Grasp the top of the rubber boot and place over the top of the device.
NOTE: To function properly, remove the entire rubber boot from the device before placing the device in a
charging cradle.
Installing the Rubber Boot on Device with Trigger Handle
1. Slide the top of the device into the top of the rubber boot.
2. Grasp the bottom of the rubber boot and place over the bottom of the device.
NOTE: To function properly, remove the entire rubber boot from the device before placing the device in a
charging cradle.
mc2200-mc2700-a10-prg-en.book Page 109 Friday, September 25, 2020 10:24 AM
To Next Page
Loading...