78
Wireless
This section provides information on the following wireless features:
• Wireless Local Area Network (WLAN)
• Bluetooth
• Cast
• Near Field Communications (NFC)
Wireless Local Area Networks
Wireless local area networks (WLANs) allow the device to communicate wirelessly inside a building.
Before using the device on a WLAN, the facility must be set up with the required hardware to run the
WLAN (sometimes known as infrastructure). The infrastructure and the device must both be properly
configured to enable this communication.
Refer to the documentation provided with the infrastructure (access points (APs), access ports, switches,
Radius servers, etc.) for instructions on how to set up the infrastructure.
Once the infrastructure is set up to enforce the chosen WLAN security scheme, use the Wireless &
networks settings configure the device to match the security scheme.
The device supports the following WLAN security options:
• Open
• Wireless Equivalent Privacy (WEP)
• Wi-Fi Protected Access (WPA)/WPA2 Personal (PSK)
• WPA/WPA2/WPA3 Enterprise (EAP)
• Lightweight Extensible Authentication Protocol (LEAP) - Only available with mDNA Enterprise
Bundle upgrade.
• Protected Extensible Authentication Protocol (PEAP) - with MSCHAPV2 and GTC authentication
NOTE: GTC authentication without a password (Dynamic GTC) requires a Mobility DNA Enterprise
License.
• Transport Layer Security (TLS)
• Tunneled Transport Layer Security (TTLS) - with Password Authentication Protocol (PAP),
MSCHAP and MSCHAPv2 authentication
• Flexible Authentication via Secure Tunneling (EAP-FAST) - with MSCHAPV2 and GTC
authentication
mc2200-mc2700-a10-prg-en.book Page 78 Friday, September 25, 2020 10:24 AM
To Next Page
Loading...