Data Capture
67
2.
Ensure that an app is open on the device and a text field is in focus (text cursor in text field).
3. Press and hold the trigger.
The red laser aiming pattern turns on to assist in aiming. Ensure the barcode is within the area formed
by the cross-hairs in the aiming pattern. The aiming dot increases visibility in bright lighting conditions.
The RS6000 LEDs light green and a beep sounds to indicate the barcode was decoded successfully.
When the RS6000 is in Pick List mode, the RS6000 does not decode the barcode until the center of the
crosshair touches the barcode.
4. The captured data appears in the text field.
mc2200-mc2700-a10-prg-en.book Page 67 Friday, September 25, 2020 10:24 AM
To Next Page
Loading...