58
QLn Series User Guide
Hand Strap
The QLn Series hand strap accessory (p/n P1031365-027) at-
taches to the printer’s cut-outs as does the shoulder strap to
provide the user with a convenient and secure method of car-
rying the printer. To attach the hand strap to the printer:
• Insert the end of the strap through the cut out on the front
of the printer as shown below.
• Loop the end of the strap back around the cut out and secure it
over the button.
• Repeat this process for the opposite end of the strap.
The QLn Series printers also feature two mounting holes on
the base of the printer to accommodate future mounting op-
tions. Refer to RAM Mount Installation Procedure
(p/n AA17518-003) on zebra.com.
Figure 37: Detachable Hand Strap (QLn420 Shown)
To Next Page
Loading...
