• 2-27 • P1057798-001 rev. B • QLn420 Repair Procedures
7. Remove the spring on each end of
the Peeler assembly.
8. Use a torque driver to remove (2)
screws holding the Peeler Arm to
the Frame and (1) screw holding
the Peeler Bail to the Frame.
9. Lift the Peeler from the Frame.
10. Flex the Frame to disengage the
tab on each end of the Printhead
Assembly from the slot on the
Frame.
11. Slide the pivot shaft from the latch
fork of the Peel Sensor Bracket
and the printhead bracket to
remove the Printhead.
To Next Page
Loading...
