P1057798-001 rev. B • QLn420 Repair Procedures • 2-28 •
Installing the Printhead Assembly and
Peeler
1. Slide Printhead Assembly between
Latch Fork as shown.
2. Slide the pivot shaft through the
Latch Fork and Printhead bracket
until the shaft exits through the
opposite end. Ensure that the pivot
shaft is centered in the bracket.
3. Place the Printhead Assembly
into the slot on the Frame (where
shown). Flex the other end of the
Frame in order to slide the tab into
the opposing slot in the Frame.
To Next Page
Loading...
