pg. 6 P1059402-001 Rev. A
Figure 2: Power suPPly VehiCle ConneCTors
To ensure the most reliable printer performance possible, Zebra
recommends the following installation techniques:
• It is very important that if a USB cable is connected to the printer while the battery eliminator
is installed, the USB cable must be no more than four (4) feet long. If a longer USB cable is
used, intermittent printer performance could be experienced. Please contact your Zebra sales
representative to obtain the proper cable.
• If installing the permanent bare-wire installation version, follow good wiring practices and
connect to a fused connection point on the vehicle electrical fuse block. (NOTE: The positive lead
(red wire) contains the fuse holder.)
Bare Wire Connector w/ Fuse
(3630 mm cord)
DC Cable (365 mm cord)
Power Adapter
(117.6 x 81.4x 39.4 mm)
LED
A green LED will light on the power supply to indicate the power is on. A red LED will light to
indicate an error condition is present. If the error condition occurs, unplug the printer from the power
supply and turn off the vehicle power. Reconnect the printer to the power supply, and if the red LED
remains on, contact technical support.
Side View
To Next Page
Loading...
