P1059402-001 Rev. A pg. 7
Bare Wire Connector w/ Fuse
(3630 mm cord)
• Turn on the printer. Load the printer with media and press the feed button to ensure that the
printer is properly connected and the media has been properly installed. The printer will be
able to print as long as the vehicle power stays on.
The power supply can be located on any convenient surface within 1.42 ft. (0.43m) of the
printer. Locate the power supply where it will receive adequate ventilation. Do not locate it near the
operator’s feet or where it could hinder operation of the system or vehicle controls. Ensure that the
cable routing does not invite damage to either the charger or the printer.
RAM Mount Installation
• Remove and retain the docking connector
cover from the base of the printer.
• Insert the two raised clips on the
mounting plate into the corresponding
openings on the bottom of the printer.
• Secure the printer to the mounting
plate with two #6 captive panel screws
(circled).
• Screw the Power Adapter to the Base
Plate. Be sure to secure the DC cable to
the plate with the wire clip (circled).
• Mount the printer onto the RAM.
• Connect the mating cable from the DC
transfer pack to the DC cable from the
Power Adapter (circled).
When attaching the QLn420 to the RAM mount and the RAM mounting plate using the RAM
Mount Kit (Zebra p/n P1050667-032), be sure to properly route the DC Transfer Pack connector
and secure the printer to the mouting plate.
To Next Page
Loading...
