Zebra QLn420 - Advanced Media Loading; QLn320;220 Peeler Activated Loading

pg. 8 P1059402-001 Rev. A
Forklift Mount Installation
• Attach the Mobile Mount Bracket to the
U-shaped bracket.
• Place the Power Adapter on the Mobile
Mount Bracket and secure with two (2)
screws (where shown).
• Secure the printer (with the DC transfer
pack) to the Mobile Mount. Be sure to
route the DC mating connector through
the slot on the Mobile Mount (circled).
• Attach the printer and Mobile Mount to
the Mobile Mount Bracket.
• Connect the mating cable from the DC
transfer pack to the DC cable from the
Power Adapter (where shown).
Note: Refer to the MM4 Mobile Mount Installation Guide (p/n P1005089 Rev. C) for detailed forklift
mounting instructions for the QLn420 printer.