Zebra S4M Installation Instructions

7
S4M Pulley and Gears Maintenance Kit
Remove the Drive Belt
10/3/05 S4M Installation Instruction 20002L-001 Rev. A
Remove the Drive Belt
1. See Figure 6. Locate the stepper motor and drive belt.
Figure 6 • Locate Drive System Components
2. Loosen the pivot screw and locking screw, then remove the stepper motor and remove the
drive belt.
1
Compound Gear
6
Drive Belt
2
Mounting Screw
7
Locking Screw
3
Intermediate Gear
8
Stepper Motor
4
Set Screw (2)
9
Pivot Screw
5
Compound Pulley
Note • The compound pulley has two drive wheels that allow for 200 or 300 dpi
operation. Note the location and orientation of the drive belt on the pulley before
removing.
8
1
2
3
4
7
9
5
6

Zebra S4M Specifications

General

Flash memory	4 MB
Internal memory	8 MB
Dimensions (WxDxH)	272 x 477 x 295 mm
Media types supported	continuous, die-cut, tag, black mark
Media thickness	0.076 - 0.15 mm
RS-232 ports	1
Standard interfaces	USB 2.0
Storage temperature (T-T)	5 - 40 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 85 %
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Weight	12400 g