Technical specification Instructions for Use
305935-9900-000–1.3 –2020-08-25-for USA 55 / 65
Wireless communication
11.7.1 Wi-Fi router information
• Release version of firmware: V1.2
• Frequency band(s): 2.4G:2.412 – 2.472 GHz
• RF Output Power:
▪ 802.11b: 19.75 dBm (EIRP)
▪ 802.11g: 19.85 dBm (EIRP)
▪ 802.11n 20MHz: 19.95 dBm (EIRP)
▪ 802.11n 40MHz: 19.75 dBm (EIRP)
• Antenna type: Dipole Antenna
• Antenna gain: 2.0 dBi
• Maximum radio-frequency power transmitted: 20 dBm ± 2.0 dBm
• Operation modes: Duplex
• Modulation Type: DSSS/OFDM
11.7.2 Statement of Class B digital device (Part 15 of the FCC Rules)
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
− Reorient or relocate the receiving antenna.
− Increase the separation between the equipment and receiver.
− Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
− Consult the dealer or an experienced radio/TV technician for help.
11.7.3 Conformity of FFC Rules
This device complies with Part 15 of the FCC Rules. Operation is subject to the two following conditions:
(1) the device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
To Next Page
