OPMI LUMERA® 700
Version 3.0
Page 2 G-30-1673-en
About this manual
The user manual is part of the delivery package.
• Carefully read it before using the device.
• Keep it at the site of use of the device.
• Store it for the entire service life of the device.
• Pass it on to every subsequent owner or user of the device.
Orientation aids
– The chapter overview at the beginning of the user manual provides a sum-
mary of all subjects.
– The contents of each chapter are specified in detail at the beginning of
each chapter.
– A list of abbreviations, key words and technical terms in the annex facili-
tates the search for specific terms.
Applicable area
This user manual applies to OPMI LUMERA 700 with the following
identification:
– Rating label number: 305953-9900-000
– Software release 1.2
Trademarks
–OPMI
®
, LUMERA
®
, Invertertube
®
, CALLISTO
®
eye and HaMode
®
are reg-
istered trademarks of Carl Zeiss Surgical GmbH.
–RESIGHT
™
and SCI
™
(Stereo Coaxial Illumination) are trademarks of Carl
Zeiss Surgical GmbH.
Information on the manufacturer:
Subject to change in design and scope of delivery and as a result of ongoing
technical development. Printed in Germany.
© Carl Zeiss Surgical GmbH 2010
All rights reserved. Reprints and reproductions, including excerpts, are not
permissible. However, this manual may be digitized and archived for internal
use. Access to this data by third parties is not permissible and must be pre-
vented.
Carl Zeiss Surgical GmbH
Carl-Zeiss-Strasse 22
73447 Oberkochen
Germany
Fax: + 49 (0) 7364 - 20 4823
Email: surgical@meditec.zeiss.com
Internet: www.meditec.zeiss.com
To Next Page
Loading...
