206-3489-O
PAGE 8
Hook Up Cable Service (CATV)
If you’re using a cable box, leave the TV on
channel 3 or 4 and use your cable box to
change channels.
If you’re using a cable box, EZ Program might
only find the channel your cable service is on
(usually channel 3 or 4). Don’t worry, that’s all
you need!
Locate the Antenna/Cable jack on the
back of the TV.
Connect the cable service wire that runs
from the wall or cable box directly to this
jack, according to one of the diagrams to
the right.
Remove the back of the remote and put in
two “AAA” batteries.
Plug in the TV. Do not plug it into an out-
let controlled by a switch. Your TV is
designed to operate on standard house-
hold current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC power.
To Next Page
Loading...
Need help?
General
