To Next PageTo Next PageWhat to do if there is no picture on my Zenith VCR?
If there's no picture on your Zenith VCR, ensure that your TV is set to the correct video input mode to receive the VCR signal. Also, check that the TV/VCR mode is set to VCR by pressing the TV/VCR button on the remote. Verify the video cable is securely connected and that the connected TV is powered on.
Why is my Zenith DVD VCR Combo remote not working?
If the remote control for your Zenith DVD VCR Combo isn't working correctly, try these steps: 1. Point the remote control directly at the remote sensor on the DVD+VCR. 2. Ensure you are within 23 ft (7 m) of the DVD+VCR. 3. Remove any obstacles between the remote and the DVD+VCR. 4. Replace the batteries in the remote with new ones. 5. If using the VCR, press the VHS button first. If using a DVD, press the DVD button first.
How to fix Zenith XBV243 with no power?
If your Zenith DVD VCR Combo has no power, the power cord might be disconnected. Ensure the power cord is securely plugged into the wall outlet.
Why is my Zenith XBV243 remote control not working?
If the remote control for your Zenith DVD VCR Combo isn't working correctly, consider the following: * Ensure you're pointing the remote at the DVD+VCR's remote sensor. * Make sure you're within 23 ft (7 m) of the DVD+VCR. * Remove any obstacles between the remote and the DVD+VCR. * Replace the batteries in the remote with new ones. * If using the VCR, press the VHS button first; for DVD, press the DVD button first.
How to fix Zenith DVD VCR Combo when there is no power?
If your Zenith DVD VCR Combo has no power, the power cord might be disconnected. Make sure to securely plug the power cord into the wall outlet.
General| Type | DVD VCR Combo |
|---|---|
| Video Format | NTSC |
| Recording Formats | VHS |
| Remote Control | Yes |
| Playback Formats | DVD, VHS |
| Connections | Composite video output |
