FACT is made from focus error signal at DSP(IC202) and is input to IC201.
And then FACT is converted into F - and F+ in IC201.
Finally, they are sent to pick - up to control a focus actuator.
IC202
pin33(FACT)
IC201
pin8(F-)
IC201
pin9(F+)
A signal flow for FACT The waveform of FACT, F- and F+
19. Focus Drive signal(FACT)
MRESET signal is output from VCR µ-COM when power is on, so IC501 is initialized.
And those(VCR µ-COM and IC501) communicate each other through DVD-DATA, DVD-CLK signals
Waveforms display each signal when power on and after power on
IC501 pin214
(FLD_CLK)
IC501 pin2
(FLD_D_
OUT)
IC501 pin215
(FLD_D_IN)
IC501 pin130
(MRESET)
IC501
pin214
IC501
pin2
IC501
pin215
IC501
pin130
The waveform when power is on The waveform after power on
20. Signals for Front micom
To Next Page
Loading...
