MFL34797058-en-simple 11/6/07 4:52 PM Page 26
APPENDIX
TROUBLESHOOTING
i Check to see if there is any object between the product and the remote control
causing obstruction. Ensure you are pointing the remote control directly at the TV.
i Ensure that the batteries are installed with correct polarity (+ to % - to -).
i Ensure that the correct remote operating mode is set: TV, VCR etc.
i Install new batteries.
>
*=_
*=_
i=m
z
x
I Check whether the product is turned on.
i Try another channel. The problem may be with the broadcast.
i Is the power cord inserted into wall power outlet?
Check your antenna direction and/or location.
i Test the wall power outlet, plug another product's power cord into the outlet
where the product's power cord was plugged in.
I This is normal, the image is muted during the product startup process. Please
contact your service center, if the picture has not appeared after five minutes.
i Adjust Color in menu option.
i Keep a sufficient distance between the product and the VCR.
i Try another channel. The problem may be with the broadcast.
i Are the video cables installed properly?
i Activate any function to restore the brightness of the picture.
i Check for local interference such as an electrical appliance or power tool.
I Station or cable product experiencing problems, tune to another station.
i Station signal is weak, reorient antenna to receive weaker station.
i Check for sources of possible interference.
i Check antenna (Change the direction of the antenna).
26
'<::3
To Next Page
Loading...
