BioHarness Bluetooth Developer Kit User Manual
Page 11
This document is confidential and does not constitute a public document.
Possession should only be under NDA or other relevant confidentiality agreement.
This document has been prepared by Zephyr Technology Ltd and is not to be distributed, copied or reproduced without permission.
9700.0026 © Zephyr Technology 2010 2010-06-02
2.4.2. Zephyr Hardware Install
The BioHarness Device is powered by a Lithium Polymer cell which is charged via a PC USB
Port. To install the hardware, simply connect to your PC in its charging cradle.
Two notification dialogues will display:
When the hardware is installed, the LED should illuminate as constant pale orange, to indicate
the Device is charging.
If the LED is green, the device may have a completely discharged internal cell (insufficient to
establish USB comms with the PC) – leave in the cradle for a few minutes, remove and replace.
The LED should illuminate pale orange.
There is no charge state indication. 90% charge will be reached in hour from fully discharged.
100% is achieved in 3 hours. The charging automatically circuit prevents over-charging.
Constant pale orange LED
indicates device is charging
To Next Page
Need help?
General