BioHarness Bluetooth Developer Kit User Manual
Page 25
This document is confidential and does not constitute a public document.
Possession should only be under NDA or other relevant confidentiality agreement.
This document has been prepared by Zephyr Technology Ltd and is not to be distributed, copied or reproduced without permission.
9700.0026 © Zephyr Technology 2010 2010-06-02
3.5. Strap Fitting & Location
Lightly moisten the ECG sensor pads for best performance.
Don’t use distilled water.Tap water should be adequate, but
an electrolyte solution of 2-3 teaspoons of table salt in a
litre of water is ideal.
The ECG will work when dry, but be more susceptible to
signal noise when the wearer is very active.
Put the garment on backwards first, for easier adjustment
of tension and alignment of the Velcro ® fastening
• Adjust the tension so that the garment is snug but
comfortable and will not move under expected activity
Position the garment so that is just below the chest
muscles
Rotate the garment to that the fasteners are centred on the
torso, with middle snap above the sternum
Attach the BioHarness device, set to transmit or recording
mode as necessary
To Next Page
Loading...