What to do if safety grille is vibrating on Zephyr Cyclone AK6500CS Ventilation Hood?
If the safety grille is vibrating on your Zephyr Ventilation Hood, it's likely that the safety grille is loose. Tighten the safety grille screw to resolve this issue.
Why are the lights not working on my Zephyr Cyclone AK6500CS?
If the blower is working, but the lights are not on your Zephyr Ventilation Hood, it could be due to a few reasons. Check if the LED light connector is disconnected and connect it. If the connector is fine, the LED light might be defective and need to be replaced. Another possibility is that the switch board or control board is defective, requiring you to change it.
What to do if the safety grille is vibrating on my Zephyr Ventilation Hood?
If the safety grille on your Zephyr Ventilation Hood is vibrating, it is likely that the safety grille is loose. To fix this, simply tighten the safety grille screw.
General safety guidelines and warnings for using the appliance.
Guidelines for proper electrical installation and connections.
Specifies recommended height, clearance, and ducting requirements.
Information on the required electrical supply and safety precautions.
Step-by-step guide for physically mounting the hood to the cabinet.
Explanation of Airflow Control Technology for CFM adjustment.
Steps to enable and configure the ACT™ feature.
General| Color | stainless steel |
|---|---|
| Hood Type | under cabinet |
| Venting Type | ducted, external |
| Temperature Sensor | no |
| Number of Fan Speeds | 3 |
| CFM | 600 cubic feet per minute |
| Sones | 5 sones |
| Control Type | slide |
| Delay Start | no |
| Interior Light | yes |
| Remote Control | no |
| Voltage | 120 volts |
Weight and Dimensions| Depth | 22 1/4 inches |
|---|---|
| Height | 6 3/8 inches |
| Width | 29 3/4 inches |
| Net Weight | 30 pounds |
To Next Page