Turning on the Desk
1 Switch on the desk using the mains switch on
the back panel
2 Set the Grand Master full on (UP).
3 Set Master A and Master B faders to zero
(DOWN).
Setting Up Presets
1 Set ALL faders at zero, Fade Time to OFF,
set Grand Master to full.
2 Turn the Mode switch to select Preset.
3 Set up one scene by setting the required
levels for each channel on the Preset A
faders, and a different scene on Preset B.
Dipless Fading Between Scenes
1 Slowly fade up Master A. The green Output
lights correspond to the desk output.
2 To manually fade in the next scene,
simultaneously push Master B up to full,
Master A down to off. You have direct control
over the speed of the scene change.
Timed Dipless Fading Between Scenes
1 Set Fade Time to 5 seconds.
2 Quickly fade up Master A; note that the scene
only reaches maximum output level after 5
seconds.
3 To crossfade to the next scene,
simultaneously push Master B up to full,
Master A down to off. The speed of the scene
change is set by the Fade Time.
4 Experiment with different Fade Times.
Flashing a Channel
1 Press Flash Function to select Flash.
2 Press one or more individual channel Flash
buttons. The channels selected have been
added into the scene at the level set by the
Grand Master.
Soloing to a Channel
1 Change the Flash Function to Solo.
2 Press one or more individual channel Flash
buttons. This time the channels selected have
come on to the level set by the Grand Master,
with all other outputs killed.
3 Release the Flash button to return the desk to
its previous state.
Flash/Solo for whole Presets
1 Press Flash Function to select Flash.
2 Set Master A down to off and push Master B
up to full.
3 Press the Master A Flash button to see the
effect of flashing a complete preset/scene.
4 Change the Flash Function to Solo.
5 Press and HOLD the Master A Flash button.
This time the complete preset/scene has
come on to the level set by the Grand Master
and all other outputs are killed.
6 Release the Flash button to return the desk to
its previous state.
Solo operates on Memory Masters and the
Sequence Memories also.
HINTS
*
Grand Master Fader
This is usually set to full on during normal desk operation.
*
Solo
The action of solo can be particularly useful for creating a
sudden dramatic change, such as lightning flash or explosion
effect.
/p7/3
Presets Mode Operation
7359500/p7/3 Page 7
To Next Page
Loading...