Controls and Components
3.5
A. Headlight
For headlight operation, see “
Handlebar Controls”, on
page 3.17.
For headlight bulb replacement, see “
Headlight Bulb
Replacement”, on page 6.22.
For headlight alignment, see“
Headlight Alignment”,
on page 6.21.
B. Front Turn Signal
For turn signal operation, see “
Handlebar Controls”,
on page 3.17.
For turn signal light bulb replacement, see “
Turn
Signal Light Bulb Replacement”, on page 6.24.
C. AC Charger Power Connection
For description and operation, see “
Power Pack”, on
page 5.1.
D. Brake/Tail Light
For brake/tail light bulb replacement, see “
Brake/Tail
LED Replacement”, on page 6.24.
E. Rear Turn Signal
For turn signal operation, see “
Handlebar Controls”,
on page 3.17.
For turn signal light bulb replacement, see “
Turn
Signal Light Bulb Replacement”, on page 6.24.
F. Kickstand
The kickstand swings out from the side and supports
the motorcycle when parked. The key switch should
be in the OFF position when parked.
G. Kickstand Switch
This switch is a safety feature that prevents motor
operation when the kickstand is down. If the kickstand
were down when riding it could contact the ground
causing you to lose control of the motorcycle and
cause personal injury.
CAUTION: Park only on a flat firm surface, otherwise the
motorcycle could fall over causing damage.
H. Integrated Power Pack Charger
For description and operation, see “
Power Pack”, on
page 5.1.
Zero Owner's Manual (S and DS).book Page 5 Wednesday, February 28, 2018 11:21 AM