Controls and Components
3.14
Display B
To select Display B with the dash in its normal operating
mode, momentarily press the SEL button twice. Press the
ADJ button to toggle through the following fields:
• Trip 2 Odometer - Displays individual trip mileage and
is reset by pressing and holding the ADJ button for 2
seconds.
• Trip AV - Displays the average energy usage during
duration of Trip 1 in watt hours (Wh), per mile (mi), or
kilometer (km), depending on the currently selected
display unit.
Note: The Trip AV is reset each time the battery is
recharged to 100%.
• Temp - Displays the temperature of the motor in
Fahrenheit (F) or Celsius (C).
Note: The temperature may not read accurately during
the first 5 miles of a ride while the application is
calibrating itself.
• Life AV - Displays the average energy usage over the
life of the motorcycle in watt hours (Wh), per mile (mi),
or kilometer (km), depending on the currently selected
display unit.
Setting the Clock
To set the clock with the dash in its normal operating
mode, press and hold the SEL button for 5 seconds, then
momentarily press the SEL button once more. The clock
display will start to flash.
• Hours - Press and release the ADJ button to increase
the hour setting.
• Minutes - Press and release the SEL button once to
select the minute display, then press and release the
ADJ button to increase the minute setting.
• Standard or 24 Hour Mode - Press and release the SEL
button to select the time format, then press the ADJ
button to select P (am/pm mode) or 24:00 (24 hour
mode).
Zero Owner's Manual (FX and FXS).book Page 14 Monday, September 11, 2017 10:13 AM
To Next Page
Loading...
Need help?
General
