General Maintenance
6.25
7. Unhook the headlight bulb spring clip (E) by pushing
down and to the side.
8. Lift up on the spring clip and remove the headlight bulb.
CAUTION: Do not touch the glass portion of the headlight
bulb. Keep the headlight bulb free of contaminants. Oil
from your fingers or contaminants will shorten the life of
the bulb. Thoroughly clean any fingerprints or
contaminants from the bulb using a clean cloth moistened
with alcohol.
9. Install the replacement headlight bulb into the lens.
10.Installation is the reverse of the removal procedure.
Turn Signal Light Bulb Replacement
1. Remove the turn signal lens screw (A) and remove the
lens.
2. Push in on the bulb, turn the bulb counterclockwise,
and then pull the bulb out.
3. Insert the new bulb into the socket, push in and turn
clockwise until it stops.
4. Install the lens and screw; tighten the screw. Do not
over-tighten the screw.
Zero Owner's Manual (FX and FXS).book Page 25 Monday, September 11, 2017 10:13 AM
To Next Page
Loading...
Need help?
General
