General Operation
4.3
OFF Position
This position is used to turn the motorcycle OFF, disabling
the electrical system.
ON Position
This position is used for operating the motorcycle. In this
position the following sequence occurs:
• Lights turn ON
• Dash display turns ON
Motorcycle Tip-Over Sensor
Your motorcycle has a tip-over sensor that will disable the
motorcycle’s drive mode in the event it is activated. If your
motorcycle’s tip-over sensor is activated:
• The motorcycle drive mode will be disabled while
tipped-over.
• The motorcycle can’t be driven or charged while in a
tipped-over state.
• Upright the motorcycle and perform one full key cycle
(turn the key to the OFF position, wait for the display to
go blank and then turn the key back to the ON position)
to reset the sensor.
Note: Altering the factory suspension or changing the
location of the MBB (Main Bike Board) may cause either
detection of a false tip-over state or disable the detection in
the case of an actual tip-over.
Zero Owner's Manual (FX and FXS).book Page 3 Monday, September 11, 2017 10:13 AM
To Next Page
Loading...
Need help?
General
