Controls and Components
3.18
A. Headlight High/Low Beam Switch
When the switch is pushed, the headlight
changes from low beam to high beam. It
stays in the selected position until it is
switched back. When in high beam position, the high
beam indicator on the lower dash illuminates.
B. Flash-to-Pass
When the headlight is in the low beam position, push
the flash-to-pass switch and the high beam illuminates
and stays illuminated until the switch is released.
When released, this switch defaults back to the low
beam position. The high beam indicator also
illuminates.
C. Front Brake Lever
The front brake lever controls the front brake when the
lever is squeezed. When braking, the throttle should
be in the closed position. The brake light also
illuminates.
D. Throttle Control
Twist the throttle in a counter-clockwise rotation (A) to
energize the motor and start the motorcycle in a
forward direction. Release the throttle and it snaps
back to the closed position (B), de-energizing the
motor, and regenerative braking begins.
When the motorcycle is moving and the throttle
control is in the fully closed position, the regenerative
braking feature activates. Regenerative braking takes
some of the energy from the moving motorcycle and
turns it back into electrical energy. This energy is then
stored in the power pack, contributing to increased
energy efficiency. A slight drag is felt when the
regenerative braking is activated. If you want to coast
without the regenerative braking, hold the throttle just
off of the fully closed position.
Zero Owner's Manual (FX and FXS).book Page 18 Monday, September 11, 2017 10:13 AM
To Next Page
Loading...
Need help?
General
