Power Pack and Charging
5.9
9. When the green charge LED becomes solid or the SOC
reads 100%, the battery system is fully charged,
disconnect the charger. When the power pack is fully
charged, disconnect the chargers and reinstall the
protective cover.
Note: If Quick Charger will be used again, cut access flap
(see dashed line (B)) in flexible protective cover before
re-installation. Do not cut across the top of the flap. Do not
completely remove flap.
Zero Owner's Manual (FX and FXS).book Page 9 Monday, September 11, 2017 10:13 AM
To Next Page
Loading...
