ADJUSTMENT
A 189 A 190 A 191
PICK UP HITCH ADJUSTMENT
Chose the position control - "P" by hy-
draulic selection control lever. Raise the
hydraulic lifting arms into the upper
position. Hitch is in its working position.
Adjust the telescopic links that way you
thread the lock nuts to guiding tube
without play. Than screw down the nut
by 5 threads. The carrier is lifted a little
by this way and hooks are moved into
their working position.
ADJUSTMENT OF PICK UP HITCH RE-
LEASING PUSH PULL CABLE
Pick up hitch is in its working position.
The push pull cable must be under
tension that way to be the lever in cab
without play. If the push pull cable is not
properly under tension, adjust it by
screwing up or down of adjusting screw
(1). Lock the screw by lock nut (2) after
finishing adjusting.
ADJUSTMENT OF HYDRAULIC INNER
CIRCUIT CONTROL LEVER FORCE
Adjust the friction force of inner circuit
lever(1) by tightening of nut (2) that way
to avoid self-loosening of lever in any
position of hydraulic inner circuit lever at
chosen draft control.
PDF byl vytvořen zkušební verzí FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
