FRONT WHEEL TREAD SETTING
A 123
FRONT WHEEL TREAD SETTING AT
NON-DRIVEN AXLE
Front wheel tread setting is provided by
sliding out and in of front axle knees (A)
at lifted axle and with corresponding
setting of adjusting elements.
ADJUSTMENT OF FRONT AXLE KNEES
- Thread out axle knee nuts (1) and remove the screws.
- Loosen the lock nuts on ball joints (2) on ball joint sockets (3) and remove
both connecting rods (4).
- Slide out or in the knees to the required tread, reassemble screws. Tighten
axle knee nuts by torque 177-196 Nm.
- First of all fix the tractor against possible movement, lift the axle by lifting jack and
support it.
- Thread the correct connecting rods (4) with marking of wheel tread (delivered as
an option) adjust the toe-in and secure by lock nuts (2,3).
- Tighten nuts by torque 122 - 136 Nm.
PDF byl vytvo’en zkuˇebns verzs FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
