LOOP 500
12
Enabling a control
To enable a control (e.g. No.2), the following keys should be pressed:
ONControl
2
Steps carried out are shown on the display as follows:
C o n t r o l _ _ 2 O N L 2 *
Execution of the command is shown on the display as follows:
D i s a b l e E n d C o n t r o l 0 0 2 T T T T T T T T T T T T L 2 *
Dis. end - indicates that a Disable operation has been completed
TTT - possible customer text (for Control No.2)
−
the DISABLE collective display will only extinguish when no further Disable is present in the control
panel.
Disable all controls
To disable all controls, the following keys should be pressed:
OFF
Control
Enabling all controls
To enable all controls, the following keys should be pressed:
ON
Control
http://www.firealarmengineers.com
To Next Page
Loading...