LOOP 500
15
Disabling all alarm devices
To disable all alarm devices, the following keys should be pressed:
OFF
Alarm
device
or
−
press the ON/OFF key in the EXT.AUD.ALARM DEVICE field
execution of the command is shown as follows on the display:
D i s a b l e a l a r m d e v i c e 0 0 0 L 2 *
Disable - indicates that disabling has been carried out
000 - the entire zone (not individual device)
Indications
−
the DISABLE LED in the EXT.AUD.ALARM DEVICE field illuminates
−
the DISABLE collective display illuminates
−
if operation of the control panel is disabled again by the key switch, the DISABLE LED will continue to be
actuated
Enabling all alarm devices
To enable all alarm devices, the following key should be pressed:
ON
Alarm
device
or
press ON/OFF key in the EXT.AUD.ALARM DEVICE field
execution of the command is shown on the display as follows:
D i s a b l e e n d a l a r m d e v i c e 0 0 0 L 2 *
Dis. end - indicates that disabling has been completed
000 = the entire zone (not individual device)
Indications
−
the DISABLE LED in the EXT.AUD.ALARM DEVICE field extinguishes
−
the DISABLE collective display only extinguish when no further Disable is present in the control panel
http://www.firealarmengineers.com
To Next Page
Loading...