LOOP 500
2
Contents
Operating instruction part 1
for the user Page
1. Overview 3
1.1. General 3
1.2. Operator control levels 3
2. Operation on the 1st operator control level 4
2.1. Fire alarm system in quiescent state 4
2.2. Fire alarm 4
2.3. Pre-alarm 5
2.4. Fault message 6
2.5. Checking displays 7
2.6. Displaying the alarm counter 7
3. Operation on the 2nd operator control level 8
4. Emergency alarm key - activating an emergency alarm 9
5. Disable / enable operations 10
5.1. Disabling/enabling zones and detectors 10
5.2. Disabling/enabling controls, deactivating and activating 11
5.3. Disabling/enabling alarm devices, deactivating and activating 14
5.4. Disabling/enabling the transmission unit 17
5.5. Disabling and enabling the Fault main output 18
6. Event memory displays 19
7. Overview of special functions 19
8. Overview of fault messages 20
Operating instruction part 2
for the service people Page
9 Operation on the operator control level 3 3
9.1. Accessing the 3rd operator control level 3
9.2. Inspection 3
9.3. Changing the password 6
9.4. Entering or changing the delay and investigation time 6
9.5. Setting the time of day 8
9.6. Setting the date 9
9.7. Altering the switching time 10
9.7.1. Altering switching times with weekly time switch controls 10
9.7.2. Altering switching times with annual time switch controls 11
9.8. Inputting or changing priority of time switch controls 12
10. Operation on the operator level 3a control 13
10.1. Cold and warm-starting the control panel 13
10.2. Setting the control panel to Programming mode 14
10.3. Setting the control panel from Programming mode 15
11. Overview of special functions 16
12. Control and indicating unit of LOOP 500 control panel, Model GB 16
http://www.firealarmengineers.com
To Next Page
Loading...