ZETTLER LOOP 500 - Deactivating;Activating Controls

LOOP 500
13
5.2.2 Deactivating and activating controls
An activated control (in case of fire) can be deactivated manually (inhibited) and it can be reactivated again
manually (see below). Should a fire alarm appear during the deactivated stage the control will be activated
automatically (provided that the second fire alarm has the same programming).
Deactivation of a control
To deactivate a control, the following keys should be pressed:
OFFControl
1
Steps carried out are shown on the display as follows:
C o n t r o l _ _ 1 O F F L 2 *
− Control 001 is deactivated
Activation of a control
To activate a control (e.g. No.1), the following keys should be pressed:
ONControl
1
Steps carried out are shown on the display as follows:
C o n t r o l _ _ 1 O N L 2 *
− Control 001 is reactivated
Deactivation of all controls
To deactivate all controls, the following keys should be pressed:
OFF
Control
− all controls are deactivated
Activation of all controls
To activate all controls, the following keys should be pressed:
ON
Control
− all controls are reactivated
http://www.firealarmengineers.com