Maintenance and Installation Instructions Edition 11.07.2006 30 of 30
Maintenance Scheme
only once after regularly after
after
operating
hours
0 h 25 h 200 h 300 h 600 h 1500 h
Maintenance
intervals
varying, depending what
occurs first
at
intervals
Mounting 7 days 1 month 3 months 6 months 12 months
Maintenance work
Attention:
after 50 km it is absolutely necessary to
retighten the wheel nuts of the installed
drive wheel with the specified tightening
torque of 140 Nm!
•
Retighten the fixing bolts of the pivoted
connection with the specified tightening
torque 34 Nm!
•
Oilchange
•
Greasing of the teeth on the pivoted
connection
•
Visual inspections
Visual inspection for oil leakage
•
•
•
General condition of the pivoted
connection (for extreme conditions, see
Chapter „Lubrication and maintenance
intervals of the pivoted connection“
•
General condition of the transmission
(e.g. damages; cracks in the housing,
noises, etc.)
•
General condition of the drive wheel
(e.g. deformation, damage, etc.)
•
General condition of the motor (e.g.
grease in the motor, tempering colours,
fan inspection, etc.)
•
Special application conditions
stored transmissions Conservation to be renewed every 6 months
Transmissions with less operating hours acc. to maintenance scheme
Transmissions with extreme operating
conditions
Intervals to be reduced by half
To Previous Page
Loading...
Need help?
General
