Zip HydroTap G5 - SECTION 4: User Maintenance; 4.1 Changing the Internal Filter

Quick Start Installation Guide
807042 v1.02 08.22 HydroTap G5 UltraCare Install Instructions
31
SECTION 13: Commissioning
13.8 Boiling calibration and cleaning
• Read the on screen information.
• BC systems offer combined boiling
calibration and cleaning.
• Touch the green arrow to run.
• Boiling calibration and cleaning process
begins.
• Monitor the on screen information.
• Touch Chilled cleaning forward arrow to
view screen of cleaning process.
• Note If ‘Chilled cleaning’ text is flashing
there is a required action on that screen
to perform (empty cold tank).
• Cleaning process begins.
• Monitor the on screen information.
• Note This is automatic unless ‘Font’
was selected in the drain away option
selection screen (see section 13.4). In this
case a manual dispense action may be
requested.